The very common questions that you should know before using Aspire Atlantis 2

Are the more up to date   aspire atlantis 2   loops good with the old Atlantis tank?
The curls are actually cross compatible which means, you can utilize either set of loops in each of the tanks. However when utilizing the 0.3 ohm Atlantis 2 curl in the Atlantis 1 the vapor and dribble tip gets heated quickly, as the Atlantis 1 doesn’t have the same wide wind stream and wide bore trickle tip as on the Atlantis V2.
What wattage is the 0.3 ohm curl suggested at? 
By 70-80W. You begin get standard vapor at 60W and it also might start up to 90W without any issues. We would prescribe utilizing it at 80W for the best flavor and for no burn hits. However do know that the Aspire Atlantis 2 was utilizing huge amounts of e-juice at the higher wattage on the lower curl. If you need to utilize less you can try the higher ohm loop at a slight lower wattage.
Will I utilize the Atlantis 1 tank extensions on the Atlantis 2?
Yes you can, in any case you will lose the wide bore trickle tip and you will utilize the dribble tip from the Atlantis 1.
Do the Melo curls fit in the Aspire Atlantis 2?
The Melo curls fit in the Atlantis 1 and also work on the Atlantis 2.0. The Atlantis 2 loop heads also fit in the Melo, but they get very hot as the Melo doesn’t have the same wind current.
Why is my iStick 50W not terminating the 0.3 ohm Atlantis 2 curl?
A few individuals had issues with the iStick 50W utilizing the 0.3 ohm curl. They get “Atomizer Low” on the screen. IStick 50W appears to work with the 0.3 ohm curl without any issues.